• Home
• FAQs
• About
• News
• Fitting Service
• Delivery
• Trade Enquiry
• Contact Us

Home > APPLE > iPhone 4 > Brodit Active Charging Holder 521164 for Apple iPhone 4

---

Brodit Active Holder 521164 for Apple iPhone 4 with Tilt Swivel

A Brodit Holder will keep your device secure and within easy reach.  When your iPhone is in the Brodit Holder the incorporated Apple Approved Griffin Powerjolt cable will ensure your battery is charged. The Brodit Holder is fitted with a tilt swivel allowing the handset to be tilted towards the driver.

Suitable for an Apple iPhone 4 and iPhone 4S

Please note if your iPhone 4 has a skin or case this would NOT be suitable and you would require a Brodit item 521165 which is adjustable to suit a device with a skin or case. NOT suitable for an iPhone 4 with an Apple bumper. 

Brodit Holders are specifically engineered for each individual device.  They have been manufactured in Karlsborg, Sweden since 1983 and are the market leader in Smartphone and Sat Nav Holders, exporting to 30 countries.  

Each Holder is manufactured to the highest standard to produce a superb finish.  Rest assured, your handset or sat nav will remain secure when in a Brodit Holder.  

Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder. 

1. To adjust the holder for your device: Loosen the screws on the back side of the holder, so the sides of the holders can be adjusted. Place the device in the holder and press the sides together so the device is firmly in place. 

2. Tighten the screws on the back side of the holder. To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 

3. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. 

4. The holder is in place.

The Brodit Mounting Solution consists of 2 parts (1) the Brodit Holder and (2) the Brodit ProClip which are vehicle specific mounts to attach your holder to.

Please use our Brodit ProClip Vehicle Search to see the positions available for your vehicle.

See our Brodit Fitting guide by clicking here

Reasons for Not buying a Cheaper Holder Imported from the Far East

For a guide to fit your Brodit Holder onto a suction mount click here

Other Brodit Holder's are available by visiting our Brodit device search