• Home
• FAQs
• About
• News
• Fitting Service
• Delivery
• Trade Enquiry
• Contact Us

Home > HTC > Wildfire S > Brodit Passive Holder 511256 for HTC Wildfire S

---

Brodit Passive Holder 511256 for HTC Wildfire S with Tilt Swivel

A Brodit Holder will keep your device secure and within easy reach.  When your HTC is in the Brodit Holder it is still possible to insert a separate charging cable or other lead.  The Brodit Holder is fitted with a tilt swivel allowing the handset to be tilted towards the driver.

Suitable for a HTC Wildfire S

Please note if your HTC has a case this would NOT be suitable.

Brodit Holders are specifically engineered for each individual device.  They have been manufactured in Karlsborg, Sweden since 1983 and are the market leader in Smartphone and Sat Nav Holders, exporting to 30 countries.  

Each Holder is manufactured to the highest standard to produce a superb finish.  Rest assured, your handset or sat nav will remain secure when in a Brodit Holder.  

Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder. The holder in the installation pictures may look slightly different from the one you have received. However, the same instructions apply. 

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. 

3. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted. 

4. The holder is in place.

The Brodit Mounting Solution consists of 2 parts (1) the Brodit Holder and (2) the Brodit ProClip which are vehicle specific mounts to attach your holder to.

Please use our Brodit ProClip Vehicle Search to see the positions available for your vehicle.

See our Brodit Fitting guide by clicking here

Reasons for Not buying a Cheaper Holder Imported from the Far East

For a guide to fit your Brodit Holder onto a suction mount click here

Other Brodit Holder's are available by visiting our Brodit device search