• Home
• FAQs
• About
• News
• Fitting Service
• Delivery
• Trade Enquiry
• Contact Us

Home > HTC > Wildfire > Brodit Active Charging Holder 513172 for HTC Wildfire for Fixed Install

---

Brodit Active Holder 513172 for HTC Wildfire with Tilt Swivel

A Brodit Holder will keep your device secure and within easy reach.  When your HTC is in the Brodit Holder your battery will remain charged. The Brodit Holder is fitted with a tilt swivel allowing the handset to be tilted towards the driver.

Install over a 2 A fuse inside the dashboard. Professional installation recommended. 12/24 Volt.

Suitable for a HTC Wildfire

Please note if your HTC has a case this would NOT be suitable. 

Brodit Holders are specifically engineered for each individual device.  They have been manufactured in Karlsborg, Sweden since 1983 and are the market leader in Smartphone and Sat Nav Holders, exporting to 30 countries.  

Each Holder is manufactured to the highest standard to produce a superb finish.  Rest assured, your handset or sat nav will remain secure when in a Brodit Holder.  

Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder.

Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Note: If you are connecting a GPS/Data device to the holder please ensure the charger unit is located in a position within easy reach of any GPS or charging adapters. 

Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle. 

Attaching the holder:

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the attaching plate. The holder is in place.

3. Placing the device in the holder: Place the device next to the holder and slide it carefully sideways into the holder. Slide the device into the holder so you hear/feel it snaps into place.

4. The holder is in place, with a device in place.

The Brodit Mounting Solution consists of 2 parts (1) the Brodit Holder and (2) the Brodit ProClip which are vehicle specific mounts to attach your holder to.

Please use our Brodit ProClip Vehicle Search to see the positions available for your vehicle.

See our Brodit Fitting guide by clicking here

Reasons for Not buying a Cheaper Holder Imported from the Far East

For a guide to fit your Brodit Holder onto a suction mount click here

Other Brodit Holder's are available by visiting our Brodit device search