skip to main content

Home > Brodit Step 1 > Apple > iPad 1 (A1219, A1337) > Holders > Holder with lock.

Holder with lock. view larger image

Holder with lock. for Apple iPad 1 (A1219, A1337)

With Pass-Through Connector and tilt swivel. 2 keys included. Visible home button.

For Apple iPad 1 (A1219, A1337) in all countries. (Item # 537139)

£109.99 inc. VAT

In Stock: 7 | Click to check lead time

7 available from our UK warehouse, order before 15:30 Mon-Fri for same day despatch (excluding holidays).
0 on order currently in transit from manufacturer.
More available to order with a lead time of 7-10 working days.

This holder is to be used when you will secure your iPad and still have it easy accessable. Perfect for use in stores, at exhibitions and any place where you want to use your iPad without having it easy removable. In order to remove the iPad from the holder you need the key or a certain amount of violence is required. The holder includes a lock and two keys. The home button is accessible when the iPad is in the holder.

All cables that can be used with the iPad can also be used with the holder, for example a charging cable or an interface cable. When you have attached the cable to the holder it is firmly in place and you do not have connect it manually to the iPad each time you put it in the holder. (Cable not included)

The holder is equipped with a tilt swivel so you can adjust the angle and easily switch between portrait and landscape mode.

Tablets should not be installed onto a carís dashboard if they block the view or block key controls. The ProClip is designed for installation of smaller devices (phones), not for large devices (tablets). If you want to place a tablet onto the carís dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

An installation of a tablet onto a vehicleís dashboard is always done on the customerís own responsibility. Brodit recommends to use tablets on the carís headrest, installed onto a Brodit headrest mount.

Also Suitable for:
For Apple iPad 1 (A1219, A1337) in all countries.

Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.

2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. Carefully, slide the device sideways into the holder so you hear/feel it snaps into place. To lock the holder: slide the lock sideways onto the left part of the holder. Press the button to lock.

3. To unlock the holder: Use the enclosed key to open the lock. Remove the lock. To remove the device from the holder: Slide it to the left then press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.

4. The holder is in place.

Holder with lock. Holder with lock. Holder with lock. Holder with lock.