skip to main content

Home > Brodit Step 1 > Apple > iPad 3rd Gen (A1416, A1430, A1403) > Holders > Holder with lock.

Holder with lock. view larger image

Holder with lock. for Apple iPad 3rd Gen (A1416, A1430, A1403)

With Pass-Through Connector and tilt swivel. 2 keys included. Visible home button.

For Apple iPad 3rd Gen (A1416, A1430, A1403) in all countries. (Item # 537244)

Brodit special order product, please contact us for details.

This holder is to be used when you want to secure your iPad and still have it easy accessable. The holder is crashtested and approved for use on Brodit's headrest mount.
 
The holder is also perfect for use in stores, at exhibitions and any place where you want to use your iPad without having it easy removable. The holder is made of extra strong plastic and is equipped with a lock. In order to remove the iPad from the holder you need the key, two keys are included.  The home button is accessible when the iPad is in the holder. All cables that can be used with the iPad can also be used with the holder, for example a charging cable or an interface cable. When you have attached the cable to the holder it is firmly in place and you do not have connect it manually to the iPad each time you put it in the holder. (Cable not included)
 
The holder is mounted onto a tilt swivel. This means that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position.
 
Tablets should not be installed onto a car's dashboard if blocking the view or key controls. ProClip is designed for use with smaller devices like smartphones. If you want to place a tablet onto a dashboard, each combination of tablet-car must be examined in detail by yourself in order to determine if such an installation is possible in the specific case. Brodit will not give any recommendations for such installations. An installation of a tablet onto a vehicle's dashboard is always done on the customer's own responsibility. Brodit recommends using tablets on the car's headrest, installed onto a Brodit headrest mount.


Also Suitable for:
For Apple iPad 2 (A1395, A1396, A1397) in all countries.
For Apple iPad 3rd Gen (A1416, A1430, A1403) in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.

2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. Carefully, slide the device sideways into the holder so you hear/feel it snaps into place. To lock the holder: slide the lock sideways onto the left part of the holder. Press the button to lock.

3. To unlock the holder: Use the enclosed key to open the lock. Remove the lock. To remove the device from the holder: Slide it to the left then press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.

4. The holder is in place.

Holder with lock. Holder with lock. Holder with lock. Holder with lock.