skip to main content

Home > Brodit Step 1 > Apple > iPad Mini (A1432, A1454, A1455) > Holders > Passive holder with tilt swivel

Passive holder with tilt swivel view larger image

Passive holder with tilt swivel for Apple iPad Mini (A1432, A1454, A1455)

For Apple iPad Mini (A1432, A1454, A1455) in all countries. (Item # 511584)

£34.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

With your iPad Mini Retina in a holder attached in the car you will always have it within easy reach. Safe, neat and convenient! You can connect e.g. a charging cable to the iPad when it is in the holder.   
 
The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the iPad into place in the holder, and to take it with you when leaving the car.


Also Suitable for:
For Apple iPad Mini (A1432, A1454, A1455) in all countries.
For Apple iPad Mini 2 (A1489, A1490, A1491) in all countries.
For Apple iPad Mini 3 (A1599, A1600) in all countries.
For Apple iPad Mini Retina in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

3. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.

4. The holder is in place.

Passive holder with tilt swivel Passive holder with tilt swivel Passive holder with tilt swivel Passive holder with tilt swivel