skip to main content

Home > Brodit Step 1 > Apple > iPhone 3G > Holders > Holder for Cable Attachment

Holder for Cable Attachment view larger image

Holder for Cable Attachment for Apple iPhone 3G

For Griffin PowerJolt cable. Adjustable holder, fits devices with skins.

For Apple iPhone 3G in all countries. (Item # 514106)

Brodit special order product, please contact us for details.

Holder with connector attachment. The choice for you who often connect a connector to your device. The connector is easy to attach to the holder, and then it connects to the device automatically when you put your device in the holder so you do not have to connect it manually each time. (Connector not included)

Only for the new Griffin PowerJolt cable without release buttons on the side.

Compare the connector in the picture with the connector on your cable in order to find the correct holder. The holder is attached onto a tilt swivel, so it can be adjusted in order to avoid light reflection on the screen. Attach onto a ProClip Mounting Platform.

Also Suitable for:
For Apple iPhone 2G in all countries.
For Apple iPhone 3G in all countries.
For Apple iPhone 3GS in all countries.

Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder. The holder in the installation pictures may look slightly different from the one you have received. However, the same instructions apply.

1. Installation of cable: Place the holder with the frontside upwards. Place the connector into the lower part of the holder. The mark pointing upwards, so you can see it when placing the connector into the holder. Place the lid over the connector, make sure the cable is in the correct position.
2. Press the parts together and flip the holder so the backside is upwards. Screw the lid into place by using the enclosed screws. The cable is in place.
Adjustment of holder: Loosen the screws in the back of the holder. Pull the sides of the holders apart.
3. Place the device in the holder. Press the sides of the holder together so the device is in a firm position but can be slided into and out of the holder. Tighten the screws in the back of the holder.
4. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. The holder is in place.

Holder for Cable Attachment Holder for Cable Attachment Holder for Cable Attachment Holder for Cable Attachment