skip to main content


10% OFF ALL Brodit use search below:

Home > Brodit Step 1 > Apple > iPhone 3GS > Holders > Active holder for fixed installation

Active holder for fixed installation view larger image

Active holder for fixed installation for Apple iPhone 3GS

With tilt swivel. 2A charger. Adjustable holder, fits devices with skins. Apple approved charging cable.

For Apple iPhone 3GS in all countries. (Item # 527106)

Brodit special order product, please contact us for details.

The choice for you who want to have your device within easy reach, attached by the dashboard instead of on the windshield mount, giving you clear sight. Active holder for fixed installation. Gives a neat installation without loose cables hanging over the interior. You can easily take the device with you when leaving the vehicle. The holder is equipped with a tilt swivel so it can be adjusted in order to avoid light reflection on the screen.
Install over a 2 A fuse inside the dashboard. Professional installation recommended. 12 Volt. Attach onto ProClip Mounting Platform.

This product supports Qualcomm QC 2.0 quick charge (provided the device supports Qualcomm QC 2.0 quick charge).

Also Suitable for:
For Apple iPhone 3G in all countries.
For Apple iPhone 3GS in all countries.

Installation Instructions

Please read all of the instructions and  look at the pictures before attaching the holder. The holder in the installation pictures may look slightly different from the one you have received. However, the same instructions apply. Connect to a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: A. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. B. Connect the Red wire to a 12 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle. 1. Loosen the screws on the back side of the holder, so the sides of the holders can be adjusted. Place the unit in the holder and press the sides together so the unit is firmly in place.  2. Screw on the screws on the back side of the holder. 3. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. 4. The holder is in place.

Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation