skip to main content

Home > Brodit Step 1 > Apple > iPhone 3GS > Holders > Holder with Pass-Through Connector

Holder with Pass-Through Connector view larger image

Holder with Pass-Through Connector for Apple iPhone 3GS

Adjustable holder, fits devices with skins.

For Apple iPhone 3GS in all countries. (Item # 915290)

Brodit special order product, please contact us for details.

Holder with pass-through connector. This means that all cables that can be used with the iPhone can also be used with the holder, for example a charging cable or an interface cable. When you have attached the cable to the holder it is firmly in place and you do not have connect it manually to the device each time you put the iPhone in the holder. (Cable not included)

You can easily take the device with you when leaving the vehicle. The holder is equipped with a tilt swivel so it can be adjusted in order to avoid light reflection on the screen. Attach onto ProClip Mounting Platform.


Also Suitable for:
For Apple iPhone 2G in all countries.
For Apple iPhone 3G in all countries.
For Apple iPhone 3GS in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder.

1. To adjust the holder to your unit: Loosen the screws on the back side of the holder, so the sides of the holders can be adjusted.

2. Place the unit in the holder and press the sides together so the unit is firmly in place. Screw on the screws on the back side of the holder.

3. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

4. The holder is in place.

Holder with Pass-Through Connector Holder with Pass-Through Connector Holder with Pass-Through Connector Holder with Pass-Through Connector