skip to main content

Home > Brodit Step 1 > Apple > iPhone 4 > Holders > Holder for Cable Attachment

Holder for Cable Attachment view larger image

Holder for Cable Attachment for Apple iPhone 4

For Griffin PowerJolt cable. Padded.

For Apple iPhone 4 in all countries. (Item # 514164)

£39.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

The choice for you who often connect an Griffin PowerJolt cable to your iPhone. You attach the Griffin-cable to the holder easily. It then connects automatically to the iPhone when you put it in the holder, so you do not have to connect the cable it manually each time.

The holder fits only for the new Griffin PowerJolt cable with release buttons on the sides. Compare the connector in the picture with the connector on your cable in order to find the correct holder. (Cable not included)

Keep your iPhone in a holder on the road and you will always have it within easy sight and reach. Safe, comfortable and convenient! The holder has a neat and discreet design which blends well with the vehicle's interior. Your iPhone is held securely in place in an upright position for maximum cellular reception.

The holder is made of ABS plastic and is padded. This means it has a plush coating which is extra protective for your device. The holder has a perfect fit. It is easy to put the device into the holder, and just as easy to take it with you when leaving the vehicle. The holder fits for iPhone without skin and without Apple original Bumper (does NOT fit for iPhone with skin or Apple original Bumper).

The holder is equipped with a tilt swivel so you can adjust the angle of your device in order to avoid light reflection on the screen. You can tilt the holder 22 in each direction. Attach onto ProClip Mounting Platform.


Also Suitable for:
For Apple iPhone 4 in all countries.
For Apple iPhone 4S in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder.

1. Attachment of cable: Remove the two screws in the lower back part of the holder and remove the small lid. Hold the lid with the opening facing toward you. Press the cable into the groove in the upper part of the lid. Adjust the length of the cable so you can fold the connector into place in the opening. Press the connector into place in the opening, mark facing toward you. Put the lid back into place in the lower back part of the holder. Screw the screws back into place so the lid is properly attached to the holder.

2. Attachment of holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

3. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

4. The holder is in place.

Holder for Cable Attachment Holder for Cable Attachment Holder for Cable Attachment Holder for Cable Attachment