skip to main content

Home > Brodit Step 1 > Apple > iPhone 4 > Holders > Holder for Cable Attachment

Holder for Cable Attachment view larger image

Holder for Cable Attachment for Apple iPhone 4

For use with Parrot MK9000-series. With tilt swivel. Padded.

For Apple iPhone 4 in all countries. (Item # 514181)

£39.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

The choice for you who use a Parrot MK9000-series with your iPhone 4. You easily attach the Parrot-cable to the holder. It then connects automatically to the iPhone when you put it in the holder, so you do not have to connect the Parrot cable it manually each time.

The holder fits only for Parrot MK9000-series Compare the connector in the picture with the connector on your cable in order to find the correct holder. (Cable not included)

Keep your iPhone in a holder on the road and you will always have it within easy sight and reach. Safe, comfortable and convenient! The holder has a neat and discreet design which blends well with the vehicle's interior. Your iPhone is held securely in place in an upright position for maximum cellular reception.

The holder is made of ABS plastic and is padded. This means it has a plush coating which is extra protective for your device. The holder has a perfect fit. It is easy to put the device into the holder, and just as easy to take it with you when leaving the vehicle. The holder fits for iPhone without skin and without Apple original Bumper (does NOT fit for iPhone with skin or Apple original Bumper).

The holder is equipped with a tilt swivel so you can adjust the angle of your device in order to avoid light reflection on the screen. You can tilt the holder 22 in each direction. Attach onto ProClip Mounting Platform.

Also Suitable for:
For Apple iPhone 4 in all countries.
For Apple iPhone 4S in all countries.

Installation Instructions

Please read all instructions and look at the pictures before attaching the holder.

1. Installation of cable: Remove the screws on the back of the holder so you can remove the back piece. Place the holder with the frontside downwards. Place the connector into the lower part of the holder (the mark poitning downward so you can not see it).

2. Place the back piece over the connector, make sure the cable is in the correct position. Screw the back piece into place using the removed screws. The cable is in place.

3. To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

4. The holder is in place.

Holder for Cable Attachment Holder for Cable Attachment Holder for Cable Attachment Holder for Cable Attachment