skip to main content

Home > Brodit Step 1 > Apple > iPhone 4 > Holders > Active holder for fixed installation

Active holder for fixed installation view larger image

Active holder for fixed installation for Apple iPhone 4

With tilt swivel. Fits devices with or without skin. Apple approved charging cable.

For Apple iPhone 4 in all countries. (Item # 527410)

£99.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

Use an active holder for your Apple device on the road and you will always have a freshly charged battery! In addition, you will always have your device within easy sight and reach. Safe, comfortable and convenient! The active holder is to be connected inside the dashboard. It provides an elegant installation without any cables hanging over the interior. The holder has a neat and discreet design which blends well with the vehicle's interior. Your device is held securely in place in an upright position for maximum cellular reception.

When you place the device in the holder, it automatically connects to the charging unit. 12 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. Professional installation recommended.

The holder is made of black Acetal plastic and has a perfect fit. It is easy to put the device into the holder, and just as easy to take it with you when leaving the vehicle. The holder fits for devices with or without skin.

The holder is equipped with a tilt swivel so you can adjust the angle of your device in order to avoid light reflection on the screen. You can tilt the holder 22 in each direction. Attach onto ProClip Mounting Platform.

This product supports Qualcomm QC 2.0 quick charge (provided the device supports Qualcomm QC 2.0 quick charge).


Also Suitable for:
For Apple iPhone 3G in all countries.
For Apple iPhone 3GS in all countries.
For Apple iPhone 4 in all countries.
For Apple iPhone 4S in all countries.
For Apple iPod Touch in all countries.
For Apple iPod Touch 2nd Generation in all countries.
For Apple iPod Touch 3rd Generation in all countries.
For Apple iPod Touch 4th Generation in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder. Note: Connect to a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Note: If you are connecting a GPS/Data device to the holder please ensure the charger unit is located in a position within easy reach of any GPS or charging adapters. Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle. Attaching the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. 3. To place the device in the holder: Place the upper part of the device in the holder, then press the device forwards and upwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the lower part of the device, in the same time pull the the device out and down from the holder. 4. The holder is in place.

Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation