skip to main content

Home > Brodit Step 1 > Apple > iPhone 4 > Holders > Holder with external antenna connection

Holder with external antenna connection view larger image

Holder with external antenna connection for Apple iPhone 4

Active holder for fixed installation, with tilt swivel. For devices WITHOUT skin. Built-in inductive antenna (FME-male). Multiband glass mount antenna (2,5 m cable) and MultiMoveClip included.

For Apple iPhone 4 in all countries. (Item # 549401)

Brodit special order product, please contact us for details.

Brodit's holder with external antenna connection provides a considerably better and more reliable mobile coverage. Works both in rural as in urban areas, in vehicles and in buildings.

Attach an external antenna onto your vehicle or in your window and connect it to the antenna cable attached to the holder. The external antenna will pick up on even the faintest signal, too weak to be recognized by your device. The signal is then transmitted wirelessly to your device via the built-in inductive antenna. It can take a while for your device to find the signal after placing it in the holder (maximum 1 minute). The holder also charges your device, it comes with a straight cable for fixed installation. This gives a neat installation without cables hanging over the interior. Professional installation recommended.

The holder is equipped with a tilt swivel and is to be mounted into a MultiMoveClip which you attach onto ProClip Mounting Platform for a safe, convenient in your vehicle. Also perfect for use in boats and summer houses. The holder is developed and produced in Sweden. Made of black Acetal plastic. Pattern protected RCD 00199475 + RCD 002001164. Please see leaflet for more information.

- Fits devices WITHOUT skin (does not fit devices with skin)
- For fixed installation, 12V
- With external antenna connection (FME-male)
- Multiband glass mount antenna with 2,5 m cable included
(for more info, see item no. 862980)
- Built-in inductive antenna
- Apple aprroved cable
-Tilt swivel, adjustable 15
- Designed and manufactured in Sweden

Also Suitable for:
For Apple iPhone 4 in all countries.
For Apple iPhone 4S in all countries.

Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder. Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Note: If you are connecting a GPS/Data device to the holder please ensure the charger unit is located in a position within easy reach of any GPS or charging adapters. Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle. Attaching the holder: 1. Place the MultiMoveClip onto the desired position. 2. Screw the MultiMoveClip into place with the enclosed screws. 3. Attach the holder by sliding it straight downward into the MultiMoveClip so you hear/feel it snaps into place. Remove the holder by pressing the latch on the MultiMoveClip and pressing/lifting the holder straight upward and out of the MultiMoveClip. 4. The holder is in place.

Holder with external antenna connection Holder with external antenna connection Holder with external antenna connection Holder with external antenna connection