skip to main content

Home > Brodit Step 1 > Apple > iPhone 4S > Holders > Holder with lock.

Holder with lock. view larger image

Holder with lock. for Apple iPhone 4S

With Cigarette Lighter Cable and USB Cable. Apple approved cable. Padded Holder. With tilt swivel. 2 keys included.

For Apple iPhone 4S in all countries. (Item # 535279)

Brodit special order product, please contact us for details.

This holder is to be used when you will secure your iPhone and still have it easy accessable. Perfect for use in the car, in stores, at exhibitions and any place where you want to use your iPhone without having it easy removable. In order to remove the unit from the holder you need the key or a certain amount of violence is required. The holder includes a lock and two keys.

The holder is equipped with an Apple approved cig-plug cable for connection to the vehicle's 12 Volt socket. When you place the iPhone in the holder, it automatically connects to the charging unit. If you have a car with USB interface, you can disconnect the cig-plug from the holder's cable in order to get a USB-cable to connect directly to the USB connector in your vehicle.

The holder is made of ABS plastic and is padded. This means it has a plush coating which is extra protective for your device. The holder has a perfect fit. It is easy to put the device into the holder, and just as easy to take it with you when leaving the vehicle. The holder fits for iPhone without skin and without Apple original Bumper (does NOT fit for iPhone with skin or Apple original Bumper).

The holder is equipped with a tilt swivel so you can adjust the angle of your device in order to avoid light reflection on the screen. You can tilt the holder 22 in each direction. Attach onto ProClip Mounting Platform.


Also Suitable for:
For Apple iPhone 4 in all countries.
For Apple iPhone 4S in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.

2. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.

3. Slide the device carefully downward into the holder. Press the lock downward onto the upper part of the holder. Press the button to lock. Use the enclosed key to open the lock. Remove the lock by pressing it upward away from the holder. Lift the device carefully upward out of the holder.

4. The holder is in place. Switch between portrait and landscape mode by turning the holder into desired position.

Holder with lock. Holder with lock. Holder with lock. Holder with lock.