skip to main content

Home > Brodit Step 1 > Apple > iPhone 6 > Holders > Holder for Cable Attachment

Holder for Cable Attachment view larger image

Holder for Cable Attachment for Apple iPhone 6

For use with Apple original Lightning to USB Cable. With tilt swivel. Padded

For Apple iPhone 6 in all countries. (Item # 514660)

£39.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

This holder for cable attachment can, combined with an Apple cable, be used for charging your iPhone. First you mount the cable into place onto the holder, then it connects automatically to your iPhone every time you place the device in the holder. You can charge you iPhone by connecting it to the carís USB socket, or use it with a USB/cig-plug adapter for the carís 12V socket.

Important: Cable not included.The cable attachment holder can be combined with Apple original Lightning to USB Cable. There are two sizes of cables depending on when you purchased your iPhone (Apple article. no. MD818ZM/A and MD818AM/A), the cable attachment block fits them both.

The holder is made of ABS plastic and is padded. This means it has a plush coating which is extra protective for your device. The holder has a perfect fit. It is easy to put the device into the holder, and just as easy to take it with you when leaving the vehicle. The holder fits for iPhone without skin.

The holder is equipped with a tilt swivel. It means you can easily adjust the angle or your device in order to avoid light reflection on the screen. It also allows you to switch between portrait and landscape mode in a second. Attach onto ProClip mounting platform and you will always have your iPhone within easy sight and reach while on the road.

Also Suitable for:
For Apple iPhone 6 in all countries.

Installation Instructions

Please read all of the instructions and look at the pictures before installing.

1. Place the connector of the cable in the hole in the lower part of the holder. Carefully press the connector downward and forward so it passes the locking and goes into the hole. Press until you hear/feel the connector snap into place in the holder.

2. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.

3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.

4. The holder is in place.

Holder for Cable Attachment Holder for Cable Attachment Holder for Cable Attachment Holder for Cable Attachment