skip to main content

Home > Brodit Step 1 > Zebra > ET51 10.1 > Holders > Charging cradle

Charging cradle view larger image

Charging cradle for Zebra ET51 10.1

Extra strength holder. For device with Rugged frame. With DC power connector (power supply NOT included). With AMPS, Vesa 75/100 holes. With USB Host.

For Zebra ET51 10.1 in all countries. (Item # 510892)

£259.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

This holder is the perfect choice when you want to have your device within reasy reach. Custom fit for devices with Rugged frame. The holder has an extra robust design. Attach the holder to any flat surface or a Pedestal Mount in a truck, distribution vehicle, warehouse etc. Predrilled AMPS and VESA 75/100 standard holes. You have full access to the camera and all buttons and outlets when the device is in the holder.
 
The holder has a DC connector to plug in a power supply. The power supply is NOT included in the holder, add one of these products in order to get charging to your device:
Item no. 941017    Cable with cigarette ligther plug, straight cable, 12V out, 3A. 12V in.
Item no. 941012    Hard wire cable for fixed installation, 12V out, 3A. 12V in.    
Item no. 941022    Cable with cigarette ligther plug, straight cable, 12V out, 2,5A. 12/24V in.
Item no. 941021    Hard wire cable for fixed installation, 12V out, 2,5A. 12/24V in.
 
Made in Sweden. Made of high grade Acetal plastic. Color: Black. Devices should not be installed onto a vehicle's dashboard if blocking the view or key controls. An installation of a device in a vehicle is always done on the customer's own responsibility.
 
 


Also Suitable for:
For Zebra ET50 10.1 in all countries.
For Zebra ET51 10.1 in all countries.
For Zebra ET55 10.1 in all countries.
For Zebra ET56 10.1 in all countries.


Installation Instructions

Please read all of the instructions and  look at the pictures before attaching the holder.
 
1. To attach the cable: Attach the cable to the device. Place the lid over the cable and screw it into place with the enclosed screws.
 
2. To attach the holder: Place the holder onto the desired position and screw it into place with the enclosed screws.
 
3. To place the device in the holder: Place the lower part of the device in the holder. Flip/press the upper part of the device forward so it snaps into place in the holder.
To remove the device from the holder: Press upwards on the upper part of the holder, at the same time pull the upper part of the device out from the holder. Lift the device up and out from the holder.
 
4. The holder is in place.

Charging cradle Charging cradle Charging cradle Charging cradle