skip to main content

Home > Brodit Step 1 > Motorola > ET1 > Holders > Holder for Locking

Holder for Locking view larger image

Holder for Locking for Motorola ET1

Active holder with cig-plug. Slim design with charger integrated in the holder. With spring stud locking. Fits unit both with and without handstrap.

For Motorola ET1 in all countries. (Item # 530363)

£174.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

This holder is to be used when you want to secure your Motorola ET1 and still have it easy accessable.

The holder is also perfect for use in stores, at exhibitions and any place where you want to use your Motorola ET1 without having it easy removable. The holder is made of extra strong plastic and is equipped with spring stud locking. Fit sunits both with and without handstrap.

Tablets should not be installed onto a car's dashboard if blocking the view or key controls. ProClip is designed for use with smaller devices like smartphones. If you want to place a tablet onto a dashboard, each combination of tablet-car must be examined in detail by yourself in order to determine if such an installation is possible in the specific case. Brodit will not give any recommendations for such installations. An installation of a tablet onto a vehicle's dashboard is always done on the customer's own responsibility. Brodit recommends using tablets on the car's headrest, installed onto a Brodit headrest mount.


Also Suitable for:
For Motorola ET1 in all countries.


Installation Instructions

Please read all of the instructions and  look at the pictures before attaching the holder.
 
1. Place the holder onto the desired position. Screw the holder into place with the enclosed screws.
 
2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. Push the spring stud locking blocks sideways to lock the unit into the holder.
 
3. To remove the device from the holder: Press the spring stud locking blocks sideways out from the holder. Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.
 
4. The holder is in place.

Holder for Locking Holder for Locking Holder for Locking Holder for Locking