skip to main content

Home > Brodit Step 1 > Motorola > ET1 > Holders > Active holder with cig-plug

Active holder with cig-plug view larger image

Active holder with cig-plug for Motorola ET1

Slim design with charger integrated in the holder. Fits unit both with and without handstrap.

For Motorola ET1 in all countries. (Item # 530411)

£129.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

Use an active holder for your Motorola ET1 while driving and you will always have a freshly charged battery! The holder provides a neat and comfortable installation -safe and convenient. The holder is equipped with a cig-plug for connection to the vehicle's 12 Volt socket.

The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the unit into place in the holder, and to take it with you when leaving the car.

Tablets (Surfpads) should not be installed onto a carís dashboard if they block the view or block key controls. ProClip (Broditís vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the carís dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

An installation of a tablet onto a vehicleís dashboard is always done on the customerís own responsibility. Brodit recommends to use tablets on the carís headrest, installed onto a Brodit headrest mount.


Also Suitable for:
For Motorola ET1 in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder.

1. Place the holder onto the desired position. Screw the holder into place with the enclosed screws.

2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder.

3. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.

4. The holder is in place.

Active holder with cig-plug Active holder with cig-plug Active holder with cig-plug Active holder with cig-plug