skip to main content

Home > Brodit Step 1 > OnePlus > 6T > Holders > Active holder with cig-plug

Active holder with cig-plug view larger image

Active holder with cig-plug for OnePlus 6T

Adjustable holder. Fits devices with skin original case/skin. With USB-cable with cig-plug adapter. With tilt swivel. 2,1A charging. 12/24V.

For OnePlus 6T in all countries. (Item # 721063)

£69.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

Keep your phone's battery fully charged in an active holder, always within easy sight and reach! Neat, discreet and convenient. With USB-cable with cig-plug adapter, choose to connect either to the vehicle's USB outlet or the 12/24V socket. You have full access to the camera and all buttons when the device is in the holder. It is easy to slide the device into place in the holder so it connects to the charging, and to take it out of the holder when leaving the car.

The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 20 and swivels 360. Mounting plate 42x50 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Attach onto ProClip Mounting Platform.

Important note!
In order to be able to transmit audio files from your device through the USB-cable, this feature must be supported by the stereo in your car. You can easily test if this works by connecting your device to the stereo with the USB/charging cable that comes with your device. Charging through USB works regardless.

This product does not support OnePlus Dash charge, (quick charge).


Also Suitable for:
For OnePlus 6 in all countries.
For OnePlus 6T in all countries.
For OnePlus 7 in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder.

1. To adjust the holder for your device: Loosen the screws on the front side of the holder, so the sides of the holders can be adjusted.

2. Place the device in the holder and press the sides together so the device is firmly in place. Adjust the positioning of the charging connector so it connects properly to the phone. Lock the charging connector into position by screwing the screw into the hole on the side of the charging connector block. Remove the device carefully. Tighten the screws on the front side of the holder.

3. To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.

4. The holder is in place.

Active holder with cig-plug Active holder with cig-plug Active holder with cig-plug Active holder with cig-plug