skip to main content

Home > Brodit Step 1 > Xplore > M60 > Holders > Active holder with cig-plug

Active holder with cig-plug view larger image

Active holder with cig-plug for Xplore M60

With swiveling top support for an extra firm installation. With tilt swivel. 3A charger. 12/24 Volt.

For Xplore M60 in all countries. (Item # 216026)

Brodit special order product, please contact us for details.

The choice for you who want to have you PDA firmly in place, properly attached and still within easy reach. The holder has a strong, robust design to withstand rough handling in professional use. The swiveling top part keeps your device extra securely in place in the holder, it "locks" the device in the holder so that it can not shake the least. It is easy to place the PDA in the holder, and to take it with you when leaving the vehicle.

Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

The holder is equipped with a tilt swivel so you can easily adjust the angle for good viewing. Attach onto a ProClip Mounting Platform or a Pedestal Mount. The charging device is automatically connected when you put the device in the holder. Connects to the vehicle's cigarette lighter socket, 12/24 Volt.


Also Suitable for:
For Xplore M6 in all countries.
For Xplore M60 in all countries.
For Zebra M6 in all countries.
For Zebra M60 in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

3. To place the device in the holder: Place the device over the holder and slide it straight downward into the holder. Turn the swiveling top support sideways in order to "lock" the device in place in the holder.
To remove the device from the holder: Turn the swiveling top support sideways in order to set the device free. Lift the device straight upward, out from the holder.

4. The holder is in place. 

Active holder with cig-plug Active holder with cig-plug Active holder with cig-plug Active holder with cig-plug