skip to main content

Home > Brodit Step 1 > Zebra > MC70 > Holders > Active holder for fixed installation

Active holder for fixed installation view larger image

Active holder for fixed installation for Zebra MC70

With tilt swivel, with integrated charger in holder. Fits devices with standard and extended battery.

For Zebra MC70 in all countries. (Item # 532044)

£89.99 inc. VAT

Special order item, lead time from manufacturer is 7-10 working days.

The cables are to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior. The charging device is integrated in the holder itself, so there is no large charging box on the cable. The holder can also be used for data transfer (adapter cable 942756).

12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended.

The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. The holder fits devices both with standard and extended battery. Attach onto ProClip Mounting Platform.


Also Suitable for:
For Motorola MC70 in all countries.
For Motorola MC75 in all countries.
For Symbol MC70 in all countries.
For Symbol MC75 in all countries.
For Zebra MC70 in all countries.
For Zebra MC75 in all countries.


Installation Instructions

Please read all of the instructions and look at the pictures before attaching the holder. Important Note: Route the cable from the holder into the vehicle dashboard and route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.

Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws.

3. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the attaching plate.

4. The holder is in place.

Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation