skip to main content

BLACK FRIDAY SALE UP TO 20% OFF

Home > Brodit Step 1 > Zebra > TC52 > Holders > Active holder for fixed installation

Active holder for fixed installation view larger image

Active holder for fixed installation for Zebra TC52

With Molex adapter system. 2,7 A charger. With tilt swivel. Fits device with Zebra Original Rugged Boot.

For Zebra TC52 in all countries. (Item # 513926)

£89.99 inc. VAT
(Black Friday Sale - Was £89.99)

Special order item, lead time from manufacturer is 7-10 working days.

BLACK FRIDAY SALE NOW ON

An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior!
 
You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection).
 
12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2,7 A charger.  Professional installation recommended. The holder is attached onto a tilt swivel so you can easily adjust your device in order to avoid light reflection. Attach onto a ProClip Mounting Platform.
 
Dimensions: 87 x 125 x 76 mm (W x H x D mm)
Weight: 315 g
Length cabel: 420 cm, (holder + pigtale 27 cm, cabel to box 77cm, box 11cm, box to open end 305 cm.


Also Suitable for:
For Zebra TC51 in all countries.
For Zebra TC52 in all countries.
For Zebra TC56 in all countries.
For Zebra TC57 in all countries.


Installation Instructions

Please read all of the instructions and  look at the pictures before attaching the holder.
 
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
 
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.
 
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.
 
4. The holder is in place.

Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation Active holder for fixed installation